![]() ![]() How about the other way round? How about creating a bootable Windows 10 USB in Linux? I have talked a lot about creating bootable USB of Linux in Windows. After booting the live media, start the installer and follow the guided installation procedure.Brief: This tutorial shows you how to create a bootable Windows 10 USB in Linux with and without a GUI tool called Ventoy.We recommend to boot the drive in UEFI mode if listed. Each command uses the same device and media but boots the PC in a different firmware mode. For example, you might see UEFI USB Drive and BIOS USB drive. You might see separate commands for the same device. From the setup utility, boot to the usb drive:.Create a bootable USB using DD/Etcher/Ventoy/Rufus.UEFI is much preferred over BIOS whenever possible. If your firmware supports UEFI then configure your device to use UEFI only in its setup utility.Otherwise, the Linux kernel may not be able to detect your drive. Make sure that your device's SATA controller is set to AHCI mode in your device's setup utility.Check the manual of your device/motherboard for further info. It may not be possible to disable the latter explicitly - try clearing the secure boot keys instead. ![]() Common keys used: Esc, Delete, F1, F2, F9, F10, F11, or F12. Boot the PC and press the manufacturer specific key to open your device's setup utility.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |